EVERBUILD® Lumberjack® Wood Preserver - Deep-Penetrating ProtectionEVERBUILD® Lumberjack® Wood Preserver

Deep-Penetrating Protection Against Rot, Decay & Fungi

EVERBUILD® Lumberjack® Wood Preserver is a solvent-free, low-odour solution based on Micro-fine active technology. It is designed to deeply penetrate all wood and joinery, providing long-lasting protection against wet rot, dry rot, decay, and fungi. The formulation allows application to damp timbers without loss of performance, making it suitable for both interior and exterior use.

Key Features & Benefits

• Micro-fine Active Technology: Ensures deeper penetration for enhanced effectiveness.
• Solvent-Free & Low Odour: Safe for use in enclosed spaces.
• Fast Drying: Touch dry in approximately 1 hour under normal conditions.
• Non-Flammable: Safe for use in high-risk work environments.
• Suitable for Damp Timber: Maintains full effectiveness even when applied to wet wood.
• Fade-Resistant Finish: Coloured variants contain ultra-lightfast pigments for long-lasting colour.

Ideal For

• Interior and exterior rough-sawn or planed timber such as floorboards, joists, roof timbers, window frames, and doors.
• Pre-treatment before overpainting, varnishing, or staining.
• Use on garden structures like sheds, fences, and decking.

Product Details

• Packaging: Available in 1L, 5L, and 25L containers.
• Colour Options: Clear, Fir Green, Dark Oak, Golden Chestnut, Red Cedar.
• Coverage: Approximately 3–4 m² per litre, depending on wood porosity.
• Drying Time: Touch dry in 1 hour; allow 24–48 hours before overcoating.
• Application Method: Brush, spray, or dipping.
• Storage: Store in original containers at moderate temperatures (5°C to 30°C).

Application Instructions

1. Surface Preparation: Ensure wood is clean, free from paint, varnish, and debris. Sand where necessary for deeper absorption.
2. Application: Shake well before use. Apply by brush, spray, or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after the first coat has soaked in but before it is dry.
3. Drying: Allow surface to dry fully before applying any topcoats or finishes. Avoid contact until dry.
4. Repeat Treatment: For high-risk areas or severe infestations, a second application is recommended.

Limitations

• Do not apply to painted or varnished surfaces without prior removal.
• Not suitable for direct contact with food or drinking water.
• Avoid use in temperatures below 5°C or during wet weather.
• Not designed as a waterproofing agent; overcoating is required for external applications.

Cleaning of Tools

Clean all tools and equipment with water immediately after use. Do not dispose into drains or watercourses.